Average Reviews:
(More customer reviews)Sloppy workmanship. I had to use a pocket knife to cut away the flashing from the molded plastic parts before it would properly fit the edge of the piece I was scribing. Design of the brass thumbnut/screw assemblies needs improvement. In order to get the pivots tight enough, I have to use a screwdriver to keep the screw from rotating as I tighten the thumbnut. If you leave the pivot tight, it is hard to adjust accurately. If you leave it loose, the setting can to easily change inadvertently. I might try using an internal lock washer under the head of the screw to hold it in place as I tighten the thumbnut. A captive nut used with a thumbscrew would have worked better. This is another example of cutting too many corners in manufacturing. I don't know of a better alternative so I will have to put up with it. It's made in China, so maybe that is part of the problem - like so many other products from China.
Click Here to see more reviews about: FastCap Accuscribe Scribing Tool
Get 20% OFF
Click here for more information about FastCap Accuscribe Scribing Tool
0 comments:
Post a Comment